The new Easy-Laser 12.0 firmware now features a handy table that lets you instantly see how well your readings repeat and save comments for them. When performing laser shaft alignment it is a best practice to take two sets of readings immediately after system setup to establish repeatability. Bad repeatability can signal measurement problems such as loose or faulty components, brackets rubbing, backlash between shafts, loose bearings and other causes. The repeatability table lets you establish confidence in your readings before you proceed to carry out adjustments on the machines.
E170 Sample Repeatability Table
Hurry and upgrade your Easy-Laser E710 shaft alignment computer to this latest firmware. It’s free!

Filed under:
by Ana Maria Delgado, CRL