Blog

Simon is a condition monitoring specialist from a local oil refinery. He contacted my office for advice about predicting flexible coupling failures. Currently, they perform basic vibration analysis on their pumps and motors using an overall meter. They have some success predicting bearing failures but the same cannot be said for couplings. Several unexpected failures shut them down this year.

Within the facility they identified 58 pump systems considered “A Critical”, meaning if they go down, the plant goes down. I suggested ultrasound as a fast, safe, and affordable solution. Specifically, the SDT270DU offered him best value. Not only could Simon use it to monitor couplings with ultrasound; it also takes vibration measurements, thus eliminating the need for Simon to carry two data collectors.

With SDT270 Simon trends bearings with vibration, replenishes lubrication with ultrasound, and finds worn and misaligned couplings.

By placing an airborne sensor near to the coupling Simon can quickly trend an evolving defect. The SDT270DU gives Simon the choice to either spot check for defects – good – or integrate all 58 couplings into his established bearing routes – best.

Find worn and misaligned couplings with SDT’s Flexible Sensor.

I explained to Simon how several clients already trend couplings using the Flexible Wand. The SDT270 collects a STATIC ultrasound measurement that gives four indicators of condition. The first two – Overall RMS and Max RMS – indicate the level of friction produced by the defect. When these indicators rise, maintenance may consider corrective alignment during a planned shutdown. The second two – Peak and Crest Factor – identify the emergence of impacting. Together, all four indicators establish a life cycle trend for each coupling.

Once impacting appears, the Peak indicator increases in step with Overall RMS. Crest Factor (CF) is a comparative ratio between Overall RMS and Peak. As CF trends higher it warns that the window for simple maintenance has narrowed. Inspectors may choose to collect a DYNAMIC measurement when CF alarms are triggered. The DYNAMIC measurement provides a visual representation of friction and impacting severity. For both STATIC and DYNAMIC measurements it’s important to define the signal acquisition time.

Without the ability to define user time, pulling the measurement trigger (M) misses key events
Instead, set the signal acquisition time to suit the asset. This slow speed example used 20sec to capture all defect data. Why use an ultrasound instrument that overlooks the importance of user defined acquisition time?

User defined signal acquisition time, available exclusively on SDT instruments, is a luxury that lends ultrasound technicians the highest level of precision. Without the ability to set the sample time, inspectors must guess when to pull the measurement trigger, and question the validity of their data. Simon explained that all 58 pumps turn at speeds above 1800 RPM. Accordingly, he should set his SDT270’s signal acquisition time to between one and three seconds. One to three seconds at 1800 RPM samples the coupling for 30-90 revolutions.

Shaft couplings are guarded for safety. Any ultrasound inspector working around rotating equipment must be required to demonstrate an understanding of company safety policies. Safety considerations are engineered into SDT sensors. The Flexible Wand’s 10mm diameter sensor is designed to access the coupling with the safety guard in place (see figure 2). The 21” long sensor sports a comfortable, ergonomic grip that allows an inspector to collect danger-free data.

Simon seemed convinced but wanted to Hear More. Since this solution was already working well at a nearby paper mill, I introduced Simon to the plant manager, Sunil, and invited them both to lunch. Sunil and Simon connected on so many common reliability issues that afternoon. He confirmed the affordability of this solution based on coupling failures alone but went on to explain how their mill was rolling out ultrasound for acoustic lubrication, steam trap monitoring, electrical inspection, and air leak management. Simon and Sunil continued their conversation well into the afternoon. They agreed that ultrasound, with its 8 primary applications for reliability, represented a fast, safe, and affordable technology with the potential to revolutionize reliability culture. I sat back, happily watching two impassioned specialists strategize about reliability culture. I love my job!

Filed under:
, by Allan Rienstra - SDT Ultrasound Solutions